Oh well, when you print on the textured PEI plates from BIQU, I found out that with every plate I have (3 pieces) the white ink comes from the plate and shows in the print itself. This happens on the Textured PEI side.
I have this on the following plates:
- Textured PEI - Smooth PEO
- Textured PEI - Smooth PEI (triangels grid)
- Textured Pei - Smooth PET (carbon look)
You can’t wash it off, it shows in about 10 prints, and then the white lines are gone and the plate is clean to use.
Especially for prints like this, this completely ruins your print and you can start over again, because the bottom side is the side to show.
Do other people also have this problem?
9 posts - 3 participants