hey
i cant be the only one who thinks WLED and electrical products inside maker supply would be nice addition???
most ppl dont like soldering i think if more ppl would know there are ways to connect stuff without soldering alot more ppl would do electrical projects!
here are some ideas wich are very very handy for makers… and i think these would sell pretty good!
-wled controller (esp32 based) 5v or 12-24v (something like Gledopto GL-MC-001WL)
-different ws2812 strips
-Led strip diffusers
-Old standard LED kit but upgraded with ws2812 LED inside
-5v usb power supply
-12-24v power supply
-2 pin cables
-2 pin wire to 2 pin led solderless connector
-2 pin wire to 2 pin wire splitter ( one in two out) solderless connector
-2 pin led to 2 pin led solderless connector
-2 pin led to 2 pin led 90 degree solderless connector
-2 pin led to 2 pin led splitter ( one in two out) solderless connector
-2 pin wire to female usb port
-2 pin on off switches
-3 pin cables
-3 pin wire to 3 pin led solderless connector
-3 pin wire to 3 pin wire splitter ( one in two out) solderless connector
-3 pin led to 3 pin led solderless connector
-3 pin led to 3 pin led 90 degree solderless connector
-3 pin led to 3 pin led splitter ( one in two out) solderless connector
-angled usb connectors , and short usb cables etc…
2 posts - 2 participants