Help with a difficult print

Hi all,

I hope an expert can help me figure out a print profile that can print these objects. From time to time, I can get them to print with a low yield, but it is very touchy especially the strange shaped one. I’ve tried with/without support, thick/thin print heights, recently I turned on max cooling, and I just can’t crack the code. I would truly appreciate any guidance. I am printing on a P1S and can heat the chamber if needed.

Here are the recent failures:

This print I cancel well before the support even started. As you can see the layers just won’t adhere.

test print_r1.3mf (86.5 KB)

Thanks so much!

5 posts - 2 participants

Read full topic