Ok as the title says I have filament stuck in the extruder head, I turned the machine off let it cool down and unscrewed the head.
Now i can see the filament but it’s just inside the top of the head, so now way to grab it with pliers.
will I be able to push it through if i reattach it and heta the head up and use a pin or something small enough to push it through or will that not work/ break my machine.
I’d rather not have to pull plugs out as I’m not sure If I’ll get them plugged back in correctly, as i have large hand and the usually don’t work well with small plugs.
Edit: I don’t have a lighter on hand so heating up a hex key isn’t an option right now.
5 posts - 2 participants