After reading the seemingly obvious question in thread:
And then searching MakerWorld for profiles with 0.8 nozzle producing very few results:
I suggest creating a contest opposite of Amazing Precission - 0.2mm nozzle Design Challenge: “Going BIG - 0.8mm nozzle design challenge!”
Personally, I’ve only ever used 0.8mm nozzle for vase mode prints of planters. Maybe a contest would result in more interesting models for 0.8? And if it’s under-utilized/under-tested maybe a better print profiles with better speeds/quality would be a positive side-effect?
7 posts - 5 participants